If you are intending on installing LED strip lights (also referred to as LED tape) you have to be able to accurately calculate the power required. Having insufficient power source will result in only some (or none) of the LEDs illuminating, or may cause irritation flicker. An over specified power source will surely cost more to buy, and will also be harder to fit as they are bigger.

To calculate the ability supply necessary for your LED power supply, you should know: Length of the strip or tape, Variety of LEDs per metre, Power consumption per LED. To calculate how big power source (in Amps) you should multiply the length of the LED tape by the amount of the LEDs per metre then multiply this by the effectiveness of the LED (.08w to .24w per LED are typical values). Then divide the worth by 12 volts to calculate the required Amperage of the power source.

(Duration of LED Strip x LEDs per Metre x LED Power) / 12 We recommend you add at least 10% for the calculated value to enable for resistance and losses in the cables. You would probably also need to permit any possible expansions or additions in the future. Most LED Strip Lights may have additional sections added using joining cables.

Calculation Examples: Example 1: A 5m roll of SMD3528 (.08w) with 60LED/m could be: (5m x 60 x .08) / 12 = 2amps 10% = 2.2Amps. Example 2: A 5m roll of SMD5050 with 60LED/m could be: (5m x 60 x .24) / 12 = 6amps 10% = 6.6Amps.

For just about any LED strips over 2 metres in length you can offer a 12volt feed to both ends from the strip a treadmill feed in the center, by cutting the strip into two and connecting the ability supply to both strips. This provides a much more even power distribution and should offer a more consistent illumination.

LED Strip Light Uses – There are two premiere factors behind using LED strips. One is efficiency – LED driver ul are incredibly efficient, with most of the power going to produce light, not heat. Their extremely longevity (20,000 hours is typical) signifies that they also do not need replaced frequently, resulting in vastly reduced lifetime costs.

The other reason is aesthetic. Leds can be produced extremely small – some LED lighting strips are as thin as 4mm – and thus can be installed in places where traditional lights would not fit. Add to this the different LED colour options, including RGB LEDs with remote controlled colour changing abilities. This gives a new range of possible lighting effects that may dramatically change the look of a room.

Unlike other traditional lights which require bundles of cables and drain a lot of power, Leds are far much easier to use and simple to install. The cluster of these miniature size lighting is fixtures made in such hapmys efficient way that they are competent at illuminating any area of your liking. Installing LED lights in your commercial or residential application can help keep environment green, save your valuable energy cost and more importantly, makes you a smart owner who follows latest technology trends.

Every lighting technology has some attributes that determines its nature and requirements of installation. Similar is the case with LED, you have to think, decide and plan precisely to have LED dimmable driver properly installed in your place. LEDs uses are versatile therefore its type and specifications will also be varied in accordance to the application. LEDs are applicable within both dry and wet areas, knowing the proper fixture readily available for each will really make your installation process easier.

LED Driver Ul – View This Business Now To Track Down Extra Information..

We are using cookies on our website

Please confirm, if you accept our tracking cookies. You can also decline the tracking, so you can continue to visit our website without any data sent to third party services.